$95.50 per kit 
(savings of $10.65)

Presser foot for HCS Voyager machine, 3 mounting holes - "Must Have Part!!"
if your machine has the Metal Frame Base that holds the hoops you will need this part

$7.15 ea

Presser foot for HCS Voyager machine, 2 mounting holes - "Must Have Part!!"
if your machine has the Black Plastic Frame Base that holds the hoops you will need this part

$7.15 ea

Bobbin Case   "L Style"    "Must Have Part!!"

Metal Bobbin (for use when winding your own bobbins) "L Style" Requires the use of ABLS

Anti-Backlash Spring (for use with MPZ00550 when winding your own bobbins) "L Style"  Be sure to Remove This Spring when using Pre-Wound Bobbin Thread !

Rotary Hook (Stainless Steel)  "L Style" "Must Have Part!!"

Tinted Plastic Front Thread Cover with Upgraded Metal Hinge ( close up of hinge ) ( replacement for the HCB16464 with plastic hinge ) To download the installation instructions please click HERE

Hook (Upper Thread) , Thin, for machine with Black Plastic Tubular Frame Base Assembly

Hook (Upper Thread), Thicker Upgraded Version for All Metal Tubular Frame Base Assembly 

Thread Cutting Device Assembly (includes fixed knife, moving knife and bobbin thread holder)

Fixed Knife

Moving Knife

Bobbin thread holder

Needle Bar Driver (Entire Assembly)  

Nylon Body for Needle Bar Driver (Black Nylon Reciprocator Only)         "Must Have Part!!"        This part is NOT shown in your HCS1201 Parts List. It is part of the HCB08063 Needle Bar Driver

Needle Bar

Needle Holder Assembly for HCS only (includes HMG12230 screw)

Needle Holder Screw - 3mm Diameter

Magic Tape with adhesive for HCS (sold per piece - 2 pieces required per machine)

Bed Cover (Upper, Stainless Steel Construction) for the Tubular Arm on the HCS Voyager.
Replace the original painted plastic Bed Cover with this stainless steel item
(click here to see a pic of the embroidery arm)

Needle Depth Gauge for all Happy Machines with "L Style" Rotary Hooks  Essential Tool!

Plastic Spring  One of these per cone to hold thread firmly against the felt, this prevents thread breaks. (12 required per machine).  Mounted directly on Thread Stand Pin before placing the cone of thread - Minimize Thread Breaks by keeping thread from getting trapped under the cone!

Grey Clip that attaches to vertical posts on rear of FRA44001 Wide Cap Frame Assembly

Screw (M3x4) for Adjusting the Cap Grip Tension (sold in packs of 10 pieces)

 Upgraded Tubular Frame Base Assembly with 3 Roller Bearings and 2 Piece Tubular Sash
This beefier assembly helps eliminate vertical bouncing vibration in the Z Axis
To see the difference between the older and the upgraded style, click HERE

 Silver Thumbscrew for HCS Voyager tubular sash and new style cap driver (M5 x 15)

Knob Bolt (Thumbscrew ) for HCS Voyager new style cap driver